Remove the lower dashboard cover on the driver’s side to reach the power module mounted above the pedals. Check for small clips and release tabs carefully to prevent cracking the plastic housing while exposing the terminal layout.
Identify each slot using the printed schematic inside the protective lid. Numbered positions correspond to lighting circuits, audio controls, and auxiliary systems, allowing precise tracking of each connection during inspection.
Label wires and connectors before detachment to avoid misplacement during reassembly. Keep a small magnetic tray for screws and clips to prevent loss and simplify restoration of the panel.
Test circuits with a handheld multimeter by measuring voltage across each terminal. Focus on windows, climate, and entertainment circuits to detect open or shorted lines before replacing any modules.
2002 PT Cruiser Cabin Power Panel Layout Guide
Access the driver-side control module by removing the lower dash panel. Look for the small clips securing the cover and gently release them to expose the array of circuit slots. Use a flashlight to identify each numbered position, which corresponds to specific electrical systems.
Verify each connector before removal and keep a detailed list of locations.
- Slot 1: Headlamp relay
- Slot 2: Turn signal and hazard circuits
- Slot 3: Brake light controller
- Slot 4: Interior lighting
- Slot 5: Auxiliary power outlets
Test continuity
using a multimeter to detect inactive lines or shorts before replacing any module, and ensure all terminals are firmly seated during reassembly.
Finding the Driver Side Electrical Panel
Remove the lower dashboard trim on the driver’s side to access the main control module. The panel is located just above the pedals near the steering column bracket. Inspect the clips carefully to avoid cracking the plastic while lifting the cover.
Identify the panel cover label which lists numbered slots for circuits controlling lights, horn, and auxiliary systems. This label serves as a reference for tracing each connector before detachment.
Use a flashlight and a small mirror to see hidden connectors at the back of the module. This helps detect any corrosion, loose terminals, or burnt contacts before performing maintenance or testing.
Note the orientation of each terminal and label wires with masking tape to simplify reassembly. Keep a magnetic tray for screws, clips, and small hardware removed from the assembly to prevent loss.
Test all circuits individually with a handheld multimeter once the panel is exposed. Focus on key systems like interior lighting, audio, and HVAC to identify any inactive or shorted connections before replacing components.