Check the engine compartment power distribution unit near the battery first, as it contains high-current protection elements for systems like starter circuits, cooling fans, ABS, and charging components.
A second panel is located inside the cabin, typically behind a trim cover near the glove compartment or under the dashboard. This section manages interior systems such as infotainment, power outlets, lighting, and control modules.
Each slot is marked with a specific amperage value, commonly 5A, 10A, 15A, 20A, and 30A. Lower ratings are used for sensors and electronic modules, while higher values support motors and heating elements. Matching the exact rating prevents wiring damage.
Use the puller tool stored in the panel cover to remove inserts and inspect the internal metal strip. A break or darkened area indicates failure. Keep spare inserts in the vehicle to restore systems like wipers or cabin electronics without delay.
2017 Ford Transit 350 Fuse Box Diagram Locations Layout and Circuit Guide
Check the main power distribution unit under the hood near the battery, as it contains protection elements for high-load systems such as starter circuits, cooling fans, ABS module, and charging components.
A secondary panel is installed inside the cabin, typically behind a trim cover near the glove compartment or under the dashboard, handling interior electronics and control systems.
- Lighting and interior lamps
- Infotainment and accessory outlets
- Power locks and window controls
- Control modules and sensors
Each slot is labeled with a number linked to a circuit list printed on the cover. Match these numbers carefully before removal to avoid disconnecting unrelated systems like transmission control or safety features.
Amperage ratings usually range from 5A to 40A, depending on circuit load. Lower values protect sensitive electronics, while higher ratings support motors and heating elements. Always install the same rating to prevent wiring damage or repeated shutdown.
Where Fuse Boxes Are Located in 2017 Ford Transit 350 and Access Points
Check two main areas: the engine compartment near the battery and the interior section behind a panel near the glove compartment, as these locations contain all primary circuit protection units.
The under-hood unit is enclosed in a sealed plastic housing with locking clips. Open the hood, press the side tabs, and lift the cover to access relays and high-current inserts assigned to systems like starter circuits, cooling fans, and ABS.
The cabin panel is positioned behind a removable trim cover on the passenger side. Pull the cover outward to reveal rows of blade-style inserts controlling interior electronics such as lighting, outlets, and control modules, then secure the cover after inspection to maintain clean contacts.