Check the panel cover label first and match each slot by amperage before removing any component, since incorrect ratings can damage wiring or onboard modules. Under the hood, the main power distribution unit sits near the battery, while a secondary block is placed inside the cabin near the dashboard side trim. Use only identical amp values such as 10A, 15A, or 20A based on the marking.
Each position corresponds to a specific circuit like headlights, fuel pump, ECU, or climate control. A broken or darkened metal strip inside the plastic housing signals failure, often linked to loss of a single system such as power windows or infotainment.
Turn off ignition and disconnect the negative battery terminal before handling electrical components to reduce risk of short circuits. Use the plastic puller stored in the panel cover to remove parts safely, and rely on the printed layout inside the lid to locate the correct slot quickly during troubleshooting.
2013 Nissan Juke fuse diagram with panel locations and relay assignments guide
Open the engine compartment panel near the battery and use the printed legend under the cover to match each slot with its circuit and amperage, checking values like 10A for lighting, 15A for accessories, and 20A–30A for motors.
High-load components such as radiator fan, ABS system, and ignition coils are connected through larger links and switching units located in the same housing, identified by position codes and symbols on the крышка.
Inside the cabin, locate the side panel near the dashboard trim and remove the cover to access circuits tied to audio system, interior lights, and control modules, verifying each slot against the labeled chart before inspection or replacement.
Test relays by swapping identical units with the same pin layout, and confirm faults when the connected system resumes operation, avoiding mismatched components that can cause unstable electrical behavior.
Exact locations of engine bay and interior fuse boxes in 2013 Nissan Juke
Open the hood and locate the main power distribution unit directly beside the battery on the driver side, covered by a rectangular plastic lid with locking tabs.
Press the clips and lift the cover to reveal high-current circuits and relays responsible for systems like cooling fan, ABS pump, and ignition control.
Confirm identification using these features:
- Black plastic housing near battery terminals
- Snap-on cover with internal labeling
- Grouped large and small blade components
For interior access, move to the driver side dashboard edge and find a removable trim panel visible when the door is open.
Pull the cover outward carefully to expose the secondary electrical block connected to cabin electronics.
Typical circuits in this section include:
- Audio and infotainment system
- Interior lighting
- Power windows and mirrors
- Diagnostic connector
Follow these steps for quick access:
- Open driver door
- Locate side trim on dashboard
- Remove panel cover by hand
- Check slot layout printed inside
Reinstall both covers securely after inspection to protect contacts from dust, moisture, and accidental shorting.