Locate the main power access panel beneath the dashboard on the driver’s side, secured with two push clips. Removing the cover reveals all protective elements for circuits controlling lighting, ignition, and climate systems.
Check each slot for labeling before attempting replacements. Circuit holders are grouped by function: engine electronics, interior convenience features, and exterior signaling components, allowing fast identification during maintenance.
Always disconnect the battery prior to adjusting or swapping any component to prevent short circuits or accidental system resets. Use a voltage tester to confirm zero current in the panel before proceeding.
Keep a reference chart inside the panel cover. Each numbered slot corresponds to a specific circuit; engine control modules, headlamps, and audio system components are clearly mapped, reducing trial-and-error troubleshooting.
Electrical Panel Access and Component Guide for 2015 Chrysler 200
Access the primary control panel by opening the driver’s side lower dashboard compartment. Two spring clips hold the cover in place; gently release them to avoid damaging the plastic housing.
Identify individual circuit holders using the printed legend inside the cover. Slots are arranged by system type, including ignition control, lighting circuits, and accessory power lines, which allows rapid troubleshooting.
Disconnect the battery before handling components to prevent shorts or accidental resets. Confirm with a multimeter that the panel has no active current before removing or inserting holders.
Label high-priority circuits such as engine electronics and brake control units to ensure accurate restoration after maintenance. Using color-coded markers helps distinguish between similar amperage holders.
Replace blown elements using the correct rating indicated on the panel legend. Do not substitute higher-rated units, as this may damage wiring or connected modules.
Inspect contact points for corrosion or loose connections during panel access. Clean terminals with a contact cleaner and ensure tight seating to maintain stable electrical performance.
Maintain an updated reference sheet near the panel for future servicing. Recording changes, additions, or removed holders prevents confusion and allows consistent troubleshooting of electrical systems.
Identifying the Location of the Main Electrical Panel
Access the primary electrical compartment by opening the lower section of the driver’s side dashboard. The panel is mounted behind a removable plastic cover secured with two clips that can be released by hand or with a small flat tool.
Verify panel positioning against the interior schematic printed on the cover. Key circuits such as ignition, lighting, and accessory modules are grouped for quick identification, making it easier to trace or replace elements without confusion.